您现在的位置:首页 >> 资讯 >> 内容

安全梯稳车(JZ-5/400型绞车)使用说明书

时间:2024-12-8 8:22:13 点击:971

  核心提示:安全梯稳车(JZ-5/400型绞车)使用说明书安全梯绞车与JZ-5/400.型绞车使用基本相同。JZ-5/400型绞车通电可以工作,安全梯稳车可以两用,通电可以工作,停电的情况下也可以工作。凿井绞车稳车Z-5/600凿井绞车在停电的情况下:操作时,先把电源开关关闭,把大齿...
JZ-5/400型绞车通电可以工作,安全梯稳车可以两用,通电可以工作,停电的情况下也可以工作。
凿井绞车稳车
Z-5/600凿井绞车
在停电的情况下:操作时,先把电源开关关闭,把大齿轮正后方的制动舌头放下,确认放下后,把电力制动器推杆松开,然后再把本厂配备的随机带的手柄两件按在减速机高速轴两端,两手柄一上一下,按好后方可工作。
凿井绞车安全梯稳车
在通电情况下,人工操作完毕后,先把手柄去掉,再把电力制动器,液压推动器推杆调整到松开前的状态后,再把齿轮后方的舌头抬起,以上操作完毕,确认无误后,方可通电工作。特别提示(手机/微信:13333923694):在人工操作时,需要有专人负责电源开关。

User Manual for Safety Ladder Stabilizing Car (JZ-5/400 Type Sinking Winch)
The JZ-5/400 winch can work when it is powered on, and the safety ladder can be used to stabilize the vehicle. It can work when it is powered on, or when it is powered off.
Stabilizing the sinking winch
Z-5/600 sinking winch
In case of power outage: When operating, first turn off the power switch, put down the brake tongue directly behind the large gear, confirm to put it down, release the electric brake push rod, and then press the two randomly equipped handles of our factory on both ends of the high-speed shaft of the reducer. Once the two handles are pressed, they can start working.
Sinking winch safety ladder stable vehicle
In the case of power on, after manual operation is completed, remove the handle first, then adjust the electric brake and hydraulic thruster push rod to the state before releasing, and then lift the tongue behind the gear. After the above operations are completed and confirmed to be correct, power on work can be carried out. Special reminder (mobile/WeChat: 13333923694): During manual operation, a dedicated person is required to be responsible for the power switch.

作者:不详 来源:网络
相关文章
共有评论 0相关评论
发表我的评论
  • 大名:
  • 内容:
  • 河南山河公司量热仪点火丝_苯甲酸坩埚_煤样标样_粉碎机制样机_坩埚叉坩埚架灰皿架(www.thxs.net) © 2011 优质产品 良好服务 美好生活.
  • 手机/微信:13333923694 QQ:908462358